加载中…ABB_800xA学习笔记189：System_800xA_Control_6.0_AC_800M_Getting_Started_29-第四章硬件配置3
(2023-11-28 18:26:55)
标签：
abbsystem_800xa_ac800m入门手册 |
分类： ABBDCS |
继续学习第四章
Reading I/O addresses from the
Application
从应用程序读取IO地址
An easy way to read the I/O address
is to open (in this case) Diagram2 in
the program editor
and check the column labeled I/O Address. Here you will find
the
读取IO地址简单的方法是在图表编辑器打开图表2（这个例子中），检查IO地址列。在这你可以看到光电管和电机的地址（见图39）
Figure 39. The I/O Address column
shows how variables are connected to I/O channels
图 39. IO地址列显示变量如何连接到IO模板
Changes made to I/O connections in
the hardware editor will be reflected in
both editors.
在硬件编辑器中修改IO连接会影响两边的编辑器。
Your
project has now been tested offline and the hardware configuration
is complete.
你的项目已经脱机测试，硬件配置完成。
Releasing Reservations
释放保留
Since you have finished the configuration, you
can release any reservations.
一旦完成配置，可以释放任何保留。
1.
右键点击MyDoors，选择释放保留
2.
弹出的对话框用域释放保留的实体。在这个例子，默认的选择足以。但是你可以输入注释。
Figure 40. Releasing
reservations
图 40. 释放保留
3. Click OK. The
reservations are released.
点击OK按钮。保留被释放
If you use environments, continue by
deploying the configuration
(described below).
Otherwise, you are ready to proceed with Section 5, Connecting
theController and Go
Online.
如果使用了环境，请继续部署配置（如下描述）。否则，你可以继续执行第五章，连接控制器，到在线模式。
Deploying Configuration
Changes
部署配置修改
This
section is only valid when using environments
此章节只有使用环境才有用。
When
you have released the reservations, you deploy the changes from
the Engineering
Environment to the Production Environment.
当你释放了保留，你从工程环境部署修改到生产环境。
1.
右键点击MyDoors项目，选择部署
The
displayed dialog box is used to select relevant destination
environment, and what entities to deploy.
部署对话框用于选择相关目标环境以及要部署的实体。
Figure 41. Deploy changes.
图 41. 部署修改
2. Click Deploy.
The project and all other modified entities are deployed to the
Production Environment.
点击部署。项目和所有的其它修改过的实体被部署到生产环境。
You are now ready to proceed with
Section 5, Connecting the Controller and
Go Online.
你现在准备执行第五章，连接到控制器，转在线。
喜欢
0
赠金笔