目的在于完成连杆模型的疲劳分析，分析两个载荷工况：A:4500N的恒定振幅载荷，fully reversed；B:4500N的任意载荷

A：第一种载荷工况

1.模型如下

2.施加边界条件

图中A，B为边界约束

3.添加载荷

Reference:J. E. Shigley, Mechanical Engineering Design, McGraw-Hill, 1st Edition, 1986, Table A-23, Figure A-23-1, pg. 673

Test Case

A rectangular plate with a circular hole is fixed along one of the end faces and a tensile pressure load is applied on the opposite face. A convergence with an allowable change of 10% is applied to account for the stress concentration near the hole. The Maximum Refinement Loops is set to 2 and the Refinement mesh control is added on the cylindrical surfaces of the hole with Refinement = 1.

Find the Maximum Normal Stress in the x direction on the cylindrical surfaces of the hole

    为了说明ANSYSWORKBENCH的分析流程，先做这样一个例子

    这是分离机械转鼓中一个重要的零件活塞：弹性模量为2E11GPa，密度为7850Kg/m3，在下侧受到水的离心液压力，在活塞顶面受到密封环的作用力，同时活塞水物料一起做高速旋转运动，转速为8500r/min。

   1.建模，工具PRO/E，简化模型如下

   2.转入到ANSYS中的有限元简化模型如下