All inlet electric valve
faceplate covers on this page fit into a 1 5/8 inch diameter hole
in a mounting bracket inside the wall. Each inlet valve can be
mounted with the lid opening up or down. Mounting screws are about
3 7/8 inches apart on center and the diameter of the vacuum hose
hole is about 1.5 inches. If you need valves that have two holes
for 110 volts click here on electric valve.
There are two metal contact points inside the hole of each valve below and two screws on the back for the low voltage wire. All valves on this page are interchangeable.
There are two metal contact points inside the hole of each valve below and two screws on the back for the low voltage wire. All valves on this page are interchangeable.
REPLACE ANY TYPE OF OLDER electric valve (except some pre-1970 that activate by PRESSING copper or a button, or any with 1.25 inch diameter holes) with any of these valves. Once you do, enjoy using our Low Voltage hose allowing you to turn the vacuum on/off at your finger tips at the hose handle! If you want, send us any questions you may have.
